APC Back UPS Pro Uninterruptible Power Supply - BR1500MS2

APC Back UPS Pro Uninterruptible Power Supply - BR1500MS2 AvailabilityCustomizable Voltage Sensitivity - Toggle between pre-determined voltage-transfer points depending on your power quality (high; medium or low sensitivity); maximizing useful battery life and protecting sensitive electronics.Boost and Trim Automatic Voltage Regulation - Gives higher application availability by correcting low and high voltage conditions without using the battery (not available on all models).Cold-start Capable - Provides temporary battery power when the utility power is out.Automatic Self-test - Periodic battery self-test ensures early detection of a battery that needs to be replaced.Battery Failure Notification - Provides early-warning fault analysis on batteries enabling timely preventive maintenance.Intelligent Battery Management - Maximizes battery performance; life; and reliability through intelligent; precision charging.Transformer-block Spaced Outlets - Protect equipment with input transformer blocks without blocking access to other receptacles.Customizable Voltage-transfer Points - Adjust the voltage points (widen or tighten the range) where your UPS transfers to battery to maximize useful battery life and protect sensitive electronics.Green Mode - Patent-pending operating mode that bypasses unused electrical components in good power conditions to achieve very high operating efficiency without sacrificing any protection.ProtectionBattery and Surge Protected Outlets - Back up and protect your hardware and data during power outages; surges and spikes.Dataline Surge Protection - Provides protection of connected equipment from power surges on the data lines.Surge Only Outlets - Protect secondary electronics from surges and spikes without reducing battery power used to run primary electronics during an outage.SafetySafety-agency Approved - Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.ManageabilityLCD Status Display - Provides key UPS status at a glance. Multiple status indicators with load and battery bar graphs.USB Connection - Use your PC to access additional power protection and management features for your UPS via a USB Port.Audible Alarms - Provides notification of changing utility power and UPS power conditions.Disconnected Battery Notification - Warns when a battery is not available to provide backup power.ServiceabilityResettable Circuit Breaker - Easy recovery from overloads; no need to replace a fuse. (Not available on Wall Tap SKUs).Simple Battery Replacement - Increases UPS availability by allowing quick; easy battery replacement.Marketing FeaturesBattery-protected and Surge-only Outlets - Reserves power capacity and run time for connected equipment that require UPS battery back-up while providing surge only protection for less critical equipment.Boost Automatic Voltage Regulation (AVR) - Preserves battery life and maximizes runtime by correcting low voltages without discharging the battery.SpecificationsOutputMax Configurable Power (Watts): 900 Watts / 1.5kVAOutput Frequency (Sync to Mains): 60 Hz +/- 3 Hz Sync to mainsTopology: Line interactiveWaveform Type: Sine waveTransfer Time: 8ms typical: 10ms maximumOutput Connections: (6) NEMA 5-15R (Battery Backup); (4) NEMA 5-15R (Surge Protection)Nominal Output Voltage: 120VInputInput Frequency: 60 Hz +/- 3 HzInput Voltage Range for Main Operations: 88 - 147VNominal Input Voltage: 120VInput Connections: NEMA 5-15PNumber of Power Cords: 1Cord Length: 6 ft. (1.8 meters)Maximum Input Current: 12.0 ABatteries and RuntimeBattery Type: Lead-acid batteryIncluded Battery Modules: 1Typical recharge time: 16 hour(s)Replacement Battery: APCRBC163RBC Quantity: 1Battery Charge Power (Watts): 16 WattsBattery Volt-Amp-Hour Capacity: 257Run Time for Load: 4m 7sCommunications and ManagementControl Panel: Multifunction LCD status and control consoleAudible Alarm: Alarm when on battery: distinctive low battery alarm: overload continuous tone alarmSurge Protection and FilteringSurge Energy Rating: 1080 JData Line Protection: Coaxial cable for CATV/SATV/modem/audio-video; RJ45 10/100/1000 Base-T Ethernet protectionFiltering: Full time multi-pole noise filtering: 5% of IEEE surge let-through: zero clamping response time: instantaneousEnvironmentalOperating Temperature: 32 - 104 F degrees (0 - 40 C degrees)Operating Relative Humidity: 0 - 95 (Non-condensing) %Operating Elevation: 0 - 10000 ft. (0 - 3048 meters)Storage Temperature: -15 - 40 C degreesStorage Relative Humidity: 0 - 95 (Non-condensing) %Storage Elevation: 0 - 10000 ft. (0 - 3048 meters)Audible noise at 1 meter from surface of unit: 45 dBAConformanceApprovals: Energy Star V2.0 (USA); FCC part 15 class B; NOM; TUV C-US certifiedStandards: FCC Part 15 class BPhysicalMaximum Dimensions (W x D x H): 3.94 x 14.49 x 10.24 in.Net Weight: 27.56 lbs. (12.5kg)Color: BlackUnits per Pallet: 16Standard WarrantyWarranty: 3 year repair or replace Price: $299.99 Order Online Here UPC: 731304426103 SKU: APCBR1500MS2 Part No: BR1500MS2

Shop for more APC Back UPS Pro Uninterruptible Power Supply - BR1500MS2 online here

Here are some more items like APC Back UPS Pro Uninterruptible Power Supply - BR1500MS2 from BuyDig you might be interested in

Shop Amazon and Check Amazon Reviews